New member here so my apologies if I did not properly insert the video link:
I have a 2013 Escape SEL with the standard reflector housing but wanted to put an HID kit it but do it correctly by putting it in a projector housing. After searching I came across some these lights which I saw on eBay but managed to get a much better price going through Alibaba. Unfortunately once receiving the lights and being told they were plug and play. They were not. The S and SE and SEL lights have two separate plugs that plug into the stock housing. After some research it turns out the plug required for this light is the same 14 pin used on the titanium. Managed to use posi-tap connectors to temporarily wiring the lights up and running a fuse tap to fuse 39 (DRL) I was able to get the lights to function as I hoped they would. Now to remove the bumper cover and install them permanently using soldier and heat shrink.