Forums

Presently at 140K trouble free miles. Cold starts and warmup driving light throttle city driving warmup before entering the highway a perfect running engine. Once in a while including ten highway miles at 60-70 mph everything is normal. Park and restart half and hr. later then having random engine misfires.  Another time the same driving loop again at operating temp having random misfires at speed dropping in Hp with a softer throttle pedal yet floor it accelerating hard, downshifting and up to 5,000 rpms pulling hard from 70 to 90 mph a strong healthy engine with zero misfires.  At traffic lights idling city driving in drive again the random missing like 2 to 3 times a second to once every 5 to 10 seconds randomly dropping cylinders a couple quick random cylinder misfires. With the AC on idling in drive you will get jerked around the idle rpms being correcting from the dropped misfire rpm's, only talking a app 75 to 150 rpm's rpm's variations. When running normal the rpm's are steady and solid even when the AC cuts on and off cycling. Disconnecting the EGR connector, the connector next to the EGR to the left of it and lower by the hard plastic PVC tube connector and at the outlet after the air filter the same random misfires. New COPS (Motor Craft not clones), plugs, crank trigger sensor, EGR valve as well the 90 degree pipe that pokes into the intake cleaned, still the same random misfiring issues. No CHECK ENGINE LIGHT or WRENCH LIGHT at the dash being the pisser then able to read a code and correct the issue. Engine coolant temp holds solid just below half gauge as when new.  The only thing I have not clean the air mass flow sensor as it looked dry and clean with the automotive "Endoscope". Mass meter spray can possibly mess up Mass Flow Meters. The sensor at the back of the intake manifold up top and horizontal pointing toward the firewall taking a dump on me?  ====================================================================Different year 2004 Escape V6 issue solved========================================================= The air mass flow sensor on the 2004 Escape had one end of a thin wire the thickness of a double hair with a tiny looking resistor bump in the middle, the end of one hair wire was floating around making random contact to one of the larger solid wire posts out to the connector of the sensor. It would read low resistance yet random contact caused by engine vibrations and temp swings.  

My 2024 Escape hybrid (non-plug in) is always going into battery saver mode, even in warmer weather and lots of stop and go driving, which should be recharging more.  Had a dead battery awhile back and had jumped by a service through Fordpass app.  Thought it originally might have been due to colder weather, but with a warmup is still doing it.  So interior lights never come on when opening a door and can't do any kind of remote checks or starts.  Could the battery or software been damaged by the jump?  

I replaced the coolant bypass adapter and performed bleeding as per instructions. No heat coming from the vents. Repeated the procedure , this time squeezing the upper radiator hose. A bit of improvement - got heat when RPMs are above 2,000. BTW, I installed a bleeder hose to from the adapter. So the next time I opened the expansion tank cap and added coolant through the bleed hose. the expansion tank overflowed, at which point I closed the pressure cap, and the bleeder hose overflowed. So I closed everything and drove car around. No improvement. I parked with car running and cracked opened the pressure cap - a few bubbles came out. closed everything and still no heat below 2,000 rpms. Am I missing something?  UPDATE - Drove the car on some errands - about 20 miles. The system finally drew coolant from the reservoir and I get heat as normal. So, the answer for bleeding is do whatever you can in your driveway, then drive around and it will fix itself. I love Ford....

Update: issue dissapeared and did not reoccur. As suspected, car needed just to relearn and recalibrate itself.

I Just replaced the battery on my Wife's escape (2019 Titanium), used Forscan to reset BMS and cleared all DTC codes. Now I'm getting "ACC not available" message. Anything else need to be reset, or it just need to learn again?

2001 escape xlt . Rear Differential Fluid level question. Dana differential. I have gotten different answers about the rear differential fluid level. Which is correct ? I know the supposed amount of fluid required. My question is: Some say fluid level should be AT  the lower plug, Some say it should be 1/2 to 3/4 inches Below the lower plug. Which is Correct ? Thanks

2020 seat memory stopped working after changing battery, the mirrors move though. Does anyone know the fix for this?

When the outside temperature is about 35 degrees Fahrenheit or colder, the power distribution panel shows power is going to all four wheels. Regardless of the speed or distance driven, the panel never shows just the front wheels receiving power. If the outside temperature is above 35 degrees, the panel shows only the front wheels being powered after a short distance I have taken the car to the dealer and they claim they cannot find anything wrong. They road tested the vehicle and said  everything was OK. Outside temperature was about 44 degrees during the road test. The dealer has not been able to find any other occurence of this problem.    Does anyone have a similar problem or know how I can contact someone in Ford emgomeeromg that might be able to solve this issue?

I strongly prefer the 2022.  The HVAC controls are not buried on the touchscreen.  I like the aesthetics of the front end better than the 2023's.

I traded my 2019 Fusion PHEV for a 2022 Escape Titanium PHEV for the increased EV range and utility.  I'm delighted with it.  I am very glad that I have the Titanium because if has, among other things, heated seats and steering wheel AND Ford 360+ driver assist features.  Note the "+".  Its lane CENTERING is fantastic, along with INTELLIGENT cruise control - automatically adjusts vehicle speed to the changing speed limit.  I also prefer the 2022 to the 2023, because the HVAC controls are physical, not buried in the touchscreen.