Jump to content


Jaba

Wiring diagram needed

Recommended Posts

Hi...Does anyone have the wiring diagram for the 2017 1.5 liter Escape? Specifically I'm looking for the fuse number 35 which is know as engine power 4 diagram...thanks

Share this post


Link to post
Share on other sites

Are you looking for the fuse location or what it supplies power to?

Share this post


Link to post
Share on other sites

Hi thanks for responding I'm looking for what is connected to this fuse because it keeps blowing

Share this post


Link to post
Share on other sites

Ah, OK. It looks like the EVAP Purge, Blocking and Vent valves, the Variable Camshaft Solenoids 1 & 2 and both oxygen sensors The connecting wire seems to be a white wire with a brown tracer (1.5L turbo model).

Of course the may be a short within the Battery Junction Box where the fuse is located as well.

Share this post


Link to post
Share on other sites

Thanks for the information!

I think I have a shorted upstream 02 sensor or it's the wire going to it that has the short, the problem is that it's intermittent which makes it hard to troubleshoot. 

Share this post


Link to post
Share on other sites

What leads you to think it's an O2 sensor?

Share this post


Link to post
Share on other sites

I disconnected the power to the downstream one to isolate it and so far the fuse hasn't blown. Since it's an intermittent problem I'll wait a few more days to make sure it doesn't blow before I replace the sensor.

Do you know which side the sensor is located?

Share this post


Link to post
Share on other sites

There are only two oxygen sensors, one just before and one after the catalytic converter.

How did you disconnect the power to the downstream sensor without actually locating the sensor?

Share this post


Link to post
Share on other sites

The connectors for both sensors are under the hood near the battery. Do you know what side under the vehicle the downstream sensor is located? I think it's the passenger side but I'm not sure.

Share this post


Link to post
Share on other sites

The upstream sensor is screwed into the catalytic converter where the exhaust enters it (almost right at the engine) and the downstream O2 is screwed in the the exhaust pipe right after the converter. The exhaust pipe runs down the middle of the vehicle so neither one is on a particular side of the vehicle, one is just more to the front of the car and the other is more towards the rear.

The connectors are different though; the upstream is a six wire connector and the downstream is a four wire connector.

Share this post


Link to post
Share on other sites

Thanks for this and all there other information you provided me

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×